Teaching by example!
Teaching by example!
I think pictures of said cat would be greatly appreciated 😉
Oof! That’s rough. With a full shop you Could build it from scratch in half the time. Can’t beat the price, though…
You can double up the handles, which also spreads the load a bit so they don’t cut into your hand as much. It is mainly for compactness and easy marketing
Guaranteed to last a lifetime, for sure!
Pretty straightforward leaves some room for ambiguity. You’re a pion until you decide you aren’t
It might be an issue with concentricity. If the nozzle is not perfectly centered it creates a step that the filament can snag on. It can then cause the already softened filament to bunch up during deretraction forming a plug in the heat break. I had this issue with cheap nozzles. Everything starts fine and after a few layers it all stops for apparently no reason. Cranking up the heat makes it better for a bit, before making it worse
Supergreen
Earmoofs
All constables are guinea pigs
Almost perfect! Of course Akansas should be Nebrahoma. Rookie mistake, but great work otherwise! Gold star
The new scrum master is working hard