I know the carve out could have been a bit better but it’s rock solid and only bothers me a lot. (I’ll fix it in the morning)

Link to the conversion boards, they’re only €10 a piece and are made by an independent maker in Norway.

    • Gormadt@lemmy.blahaj.zoneOPEnglish
      3·
      1 day ago

      It’s super easy to do

      There is part that will likely break when you do it which are the plastic clips that hold it together, but the little screws do the heavy lifting anyways so I clip them off when I open them.

      Boring out the hole on the back so it’s big enough is not as hard as it looks as long as you go slow and use the right tools. Basically a long rough needle file is needed.

      Just go slow and do a bit of research beforehand and it should go smoothly.